MILLERMATIC 210 

Features
Seven taps provides wider welding range of 30-210 amps with improved high and low ends to weld materials from 22 gauge up to 3/8 in (9.5 mm) thick in a single pass.

Easily accessible primary voltage switchover board for quick set up.

Industrial, dual-gear-driven, cast-aluminum drive system features no-tool, quick-change drive rolls and an easy-to-set tension adjustment knob with a scale for consistent settings.

Add the Spoolmate™ 3035 spool gun for aluminum welding. Easy to install with new, direct hook up. And with Miller's exclusive Gun-On-Demand™, simply pull the trigger for either gun and you're ready to weld. No time wasted toggling switches!

Removable consumable compartment and access to wire drive system located under side door.

Thermal overload protection shuts down unit if necessary to protect the machine.

Reversible drive rolls with dual grooves allow one set of drive rolls for both .030 and .035 in wire.

Built-in dual gun and cable holder for your MIG gun, spool gun and cables.

12 ft, 250 amp M-25 MIG gun features durable one-piece handle, unicable outer jacket, trigger rated for one million cycles, and steel spring coils protecting cable ends.

Miller Exclusives
Thermal Overload Protection - Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted.  « View Video »





MILLERMATIC 210 

Comes Complete With
Industrial Power cord and plug.

12 ft (3.7m), 250 amp M-25 MIG gun for .030/.035 in wire.

Factory-installed dual gas solenoids.

10 ft (3 m) work cable and clamp.

Argon mix regulator/flow gauge and hose.

Extra contact tips.

Factory-installed running gear/cylinder rack.

.030/.035 in reversible dual groove drive rolls.

Set-up and operation video.






Miller Electric Manufacturing Co. 
1635 W. Spencer St. 
P.O. Box 1079 
Appleton, WI 54912-1079 
Phone: 920-734-9821 
E-mail: Click here to E-mail us